prev next Back

Q31 series drum type shot blasting machine

Drum shot blasting machine is the use of high-speed rotating impeller of the shot blasting machine, the projectile thrown into the drum constantly turning the casting or forging to remove the surface of the residual sand or oxide scales.Clean even, high p

产品详情

Drum shot blasting machine is the use of high-speed rotating impeller of the shot blasting machine, the projectile thrown into the drum constantly turning the casting or forging to remove the surface of the residual sand or oxide scales.Clean even, high productivity.


At work, the operator places the castings to be cleaned into the drum, closes the end cap, and then adjusts the shot blasting time to start the machine in order.After the roller is turned, the diagonal bar on the plate is constantly stirring the casting, so that all the surfaces are evenly cleaned.The pellets are sent to the upper end of the separator by the elevator. The big core, burrs and other sundries are sifted out. The fine sand, dust and pellets are carried away by the airflow. The intact pellets flow into the shot thrower and continue to be used.


The cylinder of the drum type shot blasting machine is made of cast iron. The inner part of the cylinder is fixed with bolts on the guard plate. The guard plate has lattice holes and spiral guide bars so that the workpiece can be turned over when working.There is also a spiral belt for recovering projectiles between the guard plate and the drum shell.The whole roller system is supported on two pairs of supporting wheels of the machine base, and the reduction motor drives the supporting wheel through the chain and sprocket, and the roller rotates at a low speed.Because of the low rotational speed of the drum, the impact damage and the wear of the corner of the casting are less, and because of the reflection of the projectile, the casting forging with more complex shape can be cleaned up.The end cover is arranged at one end of the roller, so the loading and unloading is convenient, and it is convenient to replace the guard plate and maintain the work.If the pellet amount is too much, the pellet will leak out from the gap between the lower part of the drum and the frame. If the pellet amount is too little, the ejection amount will be less and the cleaning time will be long. Therefore, it is necessary to check the separator cover frequently when running.The projectile ejecting quantity is suitable, the reading on ammeter is about 10 ˜ 15A, when the ammeter pointer is lowered, it is proved that the projectile ejecting quantity is small, and the projectile should be added properly.If the screen at the lower part of the separator cover is blocked, the air inlet of the collector is affected.As a result, the sand separation efficiency is extremely deteriorated, so attention should be paid to remove the impurities on the screen at any time.


Name

Drum type shot blasting machine

Drum type shot blasting machine

Drum type shot blasting machine

Technical parameters of model

Q3110I

Q3113C

Q3113D

Drum diameter mm

φ1000

φ1300

φ1300

Work unit weight kg

15

40

40

Loading capacity kg

300

800

800

Shot weight kg/min

160

200

200

Shot blasting power kw

7.5

11

11

Total ventilation m3/H

800

1400

1400

Total power KW

9.35

14

14

Machine dimension (length × width × height) mm

2078×2165×1861

2700×2800×2300

2700×2800×2300



Q31 series drum type shot blasting machin...

Long by picture,save to album

Please wait while the picture is loaded
Long by picture save/share

Contact us

Address: Room 802, No. 359, Lane 885, Huancheng East Road, Fengxian District, Shanghai

Phone: 021-37525554

Contact mobile phone:18252253307

Copyright© ShangHai jaw Rong international trade Co., Ltd.all rights reserved

Copyright© ShangHai jaw Rong international trade Co., Ltd.all rights reserved